CalorvisorCalorvisor

How to Calculate Calories in Homemade Soup or Stew

Updated 2026-08-30

To calculate calories in homemade soup or stew, list every ingredient with its raw weight in grams, look up each in the USDA FoodData Central database, sum the calories, then divide by the number of servings. Account for water loss during cooking—soups typically lose 10–20% volume through evaporation, which concentrates calories per serving.

📸 Try it on your next meal — snap a photo, get the caloriesGet the app →

Why Homemade Soup Calorie Counting Differs from Store-Bought

Store-bought soups display nutrition facts on the label, making calorie tracking straightforward. Homemade soups require manual calculation because every ingredient contributes calories, and cooking methods alter final volume and concentration. Unlike a solid meal where portions are visually obvious, soup's liquid base creates ambiguity: is a serving one cup, one ladle, or half the pot?

The second challenge is ingredient variability. Your chicken broth may be homemade (nearly zero calories) or store-bought (often 10–15 calories per cup due to added oils). Your vegetables may be fresh (minimal calories) or frozen in butter sauce (added fat). The only way to know your soup's true calorie content is to track what actually goes in, measure it, and calculate based on USDA data—the same authoritative source Calorvisor uses to identify meals from photos.

Cooking also concentrates flavors and nutrients. If your stew simmers for two hours, water evaporates, meaning the same ingredients in a smaller final volume yield higher calories per serving. This is why 'before cooking' measurements matter more than the finished pot's appearance.

Step-by-Step Method: Weighing and Recording Ingredients

Begin by gathering a kitchen scale (digital scales are most accurate) and a notebook or spreadsheet. Before you start cooking, weigh every single ingredient in its raw state, in grams. For example: 500g chicken breast, 300g carrots, 200g celery, 150g onion, 1000ml chicken broth, 100g pearl barley, 2 teaspoons salt (approximately 12g). Write each down immediately—don't rely on memory.

For liquid ingredients like broth or cream, use a measuring cup to get milliliters, then convert to grams using density (1ml of water ≈ 1g; oil ≈ 0.92g/ml; cream ≈ 1.03g/ml). If using canned or packaged ingredients, check the label for the weight and note it. For fresh produce, weigh after trimming (so carrots after peeling, onions after removing papery skin). This 'as prepared' weight is what you'll look up in the USDA database.

Total the weight of all raw ingredients. If your soup starts at 2,272g of ingredients, that's your baseline. This number helps you later estimate how much water was lost during cooking, which directly affects calorie density per serving.

Count calories from a photo — skip the tables

Snap your meal and Calorvisor identifies it and works out calories and protein automatically — it even knows Albaik, Herfy, Kudu and other Saudi restaurant meals.

Try Calorvisor free

Using USDA FoodData Central to Look Up Individual Calories

The USDA's FoodData Central (fdc.nal.usda.gov) is the gold standard for nutrition data. Search for each ingredient by name—for example, 'chicken breast, raw' or 'carrot, raw.' The database returns multiple entries; select the one closest to your ingredient's form (raw vs. cooked, canned vs. fresh). Each entry shows calories per 100g, which you'll multiply by your ingredient's weight and divide by 100.

Example calculation: You used 500g raw chicken breast. FoodData Central lists raw chicken breast at 165 calories per 100g. Multiply: (500 ÷ 100) × 165 = 825 calories from chicken. Do this for every ingredient. Carrots (300g raw) at 41 cal/100g = 123 calories. Celery (200g raw) at 14 cal/100g = 28 calories. Onion (150g raw) at 40 cal/100g = 60 calories. Pearl barley (100g raw) at 352 cal/100g = 352 calories. Broth (1000ml, typically 15 cal/100ml for low-sodium) = 150 calories. Salt contributes negligible calories.

Sum all ingredient calories: 825 + 123 + 28 + 60 + 352 + 150 = 1,538 calories total in the raw ingredients. This is your starting point. Note that cooking does not destroy calories—it only changes water content and thus the concentration per serving.

Accounting for Water Loss During Cooking

When soup or stew simmers, water evaporates. A pot that weighed 2,272g of raw ingredients might weigh 1,900g after two hours of cooking—a loss of 372g (about 16%). This matters because you're dividing total calories by final servings, not raw ingredients. If you ignore evaporation, you'll underestimate calories per serving.

To measure final weight, let your soup cool slightly, then weigh the entire pot (including the pot itself). Subtract the pot's weight to get the soup's weight. For example: pot + soup = 2,100g; pot alone = 200g; soup = 1,900g. Divide total calories (1,538) by final weight in grams (1,900) to get calories per gram: 1,538 ÷ 1,900 = 0.81 calories per gram.

Alternatively, if you don't want to weigh the final pot, estimate water loss at 10–20% for simmered soups and 5–15% for stews (which have less surface area exposed). Using 16% loss: 2,272g × 0.84 = 1,908g final weight. Divide calories by this: 1,538 ÷ 1,908 = 0.81 cal/gram. The results are nearly identical, confirming the method's reliability.

Converting Per-Gram Calories to Per-Serving Portions

Once you know calories per gram, multiply by your serving size. If you eat one cup (240ml) of soup, and soup has a density close to water (1g/ml), that's 240g per serving. Multiply: 240g × 0.81 cal/g = 194 calories per cup. If you eat two cups, that's 388 calories. This method is precise because it accounts for your actual portion, not an arbitrary 'serving size' on a label.

For stews with chunky ingredients, portion size is trickier. A ladle might hold 200ml, or a bowl might hold 300ml—measure yours with water first. If your stew weighs 1,900g total and you divide it into six equal portions (317g each), each portion contains 317g × 0.81 cal/g = 257 calories. Label your containers if freezing portions, or use a kitchen scale each time you serve.

Document your calculation in a spreadsheet or note: 'Chicken & vegetable stew: 1,538 total calories, 1,900g final weight, 0.81 cal/g. One 250g serving = 203 calories.' This record lets you quickly estimate calories if you make the same recipe again, though ingredient variability means you should recalculate if you change brands or sources.

Common Mistakes and How to Avoid Them

Mistake #1: Using cooked ingredient calories instead of raw. If you look up 'chicken, cooked' (205 cal/100g) instead of 'chicken, raw' (165 cal/100g), you'll overestimate because cooking removes water, concentrating the calories. Always use raw weights and raw calorie values unless you're certain your ingredient was pre-cooked before adding to the pot.

Mistake #2: Forgetting to include oil, butter, or cream. A tablespoon of olive oil (14g) adds 120 calories—easy to overlook if you're focused on vegetables. Every fat used for sautéing, every splash of cream, every pat of butter must be weighed and logged. These are calorie-dense and significantly impact the total.

Mistake #3: Ignoring sodium broth's calorie content. A 'low-sodium' broth might be 15 cal/100ml, but a regular broth can be 20–30 cal/100ml due to added fats and gelatin. If you use 1 liter of broth, the difference between 150 and 300 calories is substantial. Check the label or USDA entry for your specific broth.

Mistake #4: Not accounting for evaporation. Assuming the final soup weighs the same as raw ingredients leads to underestimating calories per serving. Always weigh the final pot or estimate 10–20% water loss.

Mistake #5: Changing the recipe without recalculating. If you add extra potatoes or use a different type of meat, the total calories change. Recalculate rather than guessing—precision is the point of this method.

  • Always weigh raw ingredients in grams before cooking
  • Use USDA FoodData Central for calorie values, not guesses or app estimates
  • Account for water evaporation by weighing the final pot or estimating 10–20% loss
  • Include every fat, oil, and liquid—they're calorie-dense and easy to forget
  • Divide total calories by final weight in grams to get calories per gram, then multiply by your serving size

Practical Tools and Apps to Simplify the Process

A digital kitchen scale (±1g accuracy) is non-negotiable. They cost $15–40 and are far more reliable than eyeballing portions. A spreadsheet (Google Sheets or Excel) lets you build a template: ingredient name, raw weight in grams, USDA calories per 100g, calculated calories. Fill it in once, and the formulas do the math. For future batches of the same recipe, you only need to update ingredient weights.

The USDA FoodData Central website is free and authoritative. Bookmark it. Some apps like MyFitnessPal pull USDA data, though their databases may also include user-submitted entries that can vary in accuracy depending on how they were logged. Stick with the official USDA source when precision matters. If you're already using Calorvisor to photograph and log other meals, you can manually enter your calculated soup calories into it for a unified food diary—the app's barcode scanner and photo recognition work for packaged ingredients and finished dishes, but for homemade recipes, your manual calculation is the most accurate input.

Consider keeping a 'recipe database' of soups and stews you make regularly. Once you've calculated calories for your signature minestrone or beef stew, you can reuse that calculation (with minor adjustments if ingredient quantities shift). This saves time and ensures consistency.

Real-World Example: Calculating a Lentil & Vegetable Soup

Let's walk through a complete example. You're making lentil soup with: 200g red lentils (raw), 2 medium carrots (200g), 1 onion (150g), 3 cloves garlic (9g), 1 tablespoon olive oil (14g), 1 liter low-sodium vegetable broth, 1 teaspoon salt (6g), and black pepper (negligible). Total raw weight: 200 + 200 + 150 + 9 + 14 + 1000 + 6 = 1,579g.

USDA calorie lookups: Red lentils, raw = 353 cal/100g → (200÷100)×353 = 706 cal. Carrots, raw = 41 cal/100g → (200÷100)×41 = 82 cal. Onion, raw = 40 cal/100g → (150÷100)×40 = 60 cal. Garlic, raw = 149 cal/100g → (9÷100)×149 = 13 cal. Olive oil = 884 cal/100g → (14÷100)×884 = 124 cal. Vegetable broth, low-sodium = 12 cal/100ml → (1000÷100)×12 = 120 cal. Salt = 0 cal. Total: 706 + 82 + 60 + 13 + 124 + 120 = 1,105 calories.

After simmering for 45 minutes, you weigh the pot: pot + soup = 1,750g; pot = 200g; soup = 1,550g. Water loss = 1,579 − 1,550 = 29g (1.8%, minimal for a shorter cook time). Calories per gram: 1,105 ÷ 1,550 = 0.71 cal/g. One serving (250ml, approximately 250g) = 250 × 0.71 = 178 calories. Six servings from the pot, each about 178 calories. You can now log this accurately in your food diary.

Once you've calculated your soup's calories, log it in Calorvisor to track your daily intake alongside other meals—the app makes it easy to maintain a complete food diary.

Get Calorvisor free

Frequently asked questions

Do I need to use raw ingredient weights, or can I use cooked weights?

Always use raw weights and raw calorie values from the USDA. Cooking removes water, concentrating calories per 100g, so using cooked values would overestimate. The only exception is if an ingredient was pre-cooked before adding to your soup (e.g., canned beans already cooked), in which case use the cooked USDA entry for that ingredient.

What if I don't know the exact weight of an ingredient?

Weigh it. A kitchen scale costs $15–40 and is essential for accuracy. If you truly cannot weigh something (e.g., you're at a restaurant), estimate using visual comparisons: a medium carrot ≈ 70g, a medium onion ≈ 150g. But for homemade cooking, weighing is the standard.

Does cooking destroy calories?

No. Cooking does not destroy calories—it only changes the food's water content and thus the calorie density per gram or per serving. A 100g piece of raw chicken has the same calories as the same chicken after cooking, but the cooked version weighs less (due to water loss), so calories per 100g appear higher. This is why you calculate based on raw weights.

How much water loss should I expect?

Simmered soups typically lose 10–20% of their weight; stews with lids lose 5–15%. The best method is to weigh the final pot. If you can't, estimate conservatively at 15% loss and recalculate if the result seems off after a few batches.

Can I use an app to calculate soup calories instead of doing it manually?

Apps like MyFitnessPal can help, but they rely on user-submitted entries that may vary in accuracy depending on how carefully portions and ingredients are logged. For maximum precision, calculate using the official USDA FoodData Central database and your own measurements. You can then log the final result in any app, including Calorvisor, for your food diary.

Sources & method

Calorie and macro values on this page are Calorvisor reference estimates, calculated from USDA FoodData Central entries and the Atwater method, and cross-checked with USDA FoodData Central where it publishes data. They are not official publications of USDA FoodData Central. Values vary by recipe, brand and portion.

This is general nutrition information, not medical advice. Talk to a doctor or registered dietitian before changing your diet, especially if you are pregnant, under 18, or managing a medical condition.

Written and fact-checked by the Calorvisor editorial team with AI assistance. Last reviewed 2026-08-30.

Part of the guide: How to Count Calories from a Photo of Food

Related reading

Count calories from a photo — skip the tables

Snap your meal and Calorvisor identifies it and works out calories and protein automatically — it even knows Albaik, Herfy, Kudu and other Saudi restaurant meals.

Try Calorvisor free